Your Workshop

Why do some electric tools’ plugs have three prongs, while others have only two? Is one version safer than the other?

I recently made cove molding on my tablesaw. But after the job was done, I noticed a dark stain in the cast iron on the outfeed side of the cove cut. What caused this?

I’d like to enclose my shop’s dust collector to reduce the noise it makes during use. What do I need to know before tackling this?

Since I installed ceiling-mounted air-filtration units to supplement the cyclone dust collector piped to my machines, the shop has never been so clean! Should I still wear a dust mask?

Roll with the technical advances in lighting and brighten up your shop with LEDs. You’ll see better, save money, and change lightbulbs far less often.