You are here

Tablesaw tricks for accurate cuts

Precise angled cuts rely on accurate gauge settings. Here’s how to adjust yours.

Submitted by WOOD community member WOOD Magazine StaffSubmit a Shop Guide
  • Start with an adjustable drafting square.

    Use a drafting square to check the blade bevel-angle settings for the 0° and 45° stops. Adjust the bevel stops as needed for dead-on angles.

  • Check against the sawblade plate

    Verify the angle settings on your miter gauge, particularly those miter gauges with stops, against the sawblade plate. Adjust your miter gauges as needed.

  • Adjust and verify

    Adjust any inaccurate miter-gauge angle stops using a screwdriver, and verify the settings to the blade again as shown in slide 2.

  • Sand for a smooth fit if necessary

    If your miter gauge bar fits too tightly in the slot, rub one edge along 150-grit, self-adhesive sandpaper, applied to your saw's tabletop, until the gauge bar glides smoothly.

  • Dimples can take out the slop

    If your miter gauge bar fits too loosely in the slot and doesn't have adjustment screws, add dimples every 4-6" by peening it with a hammer and punch.

  • More resources

    Free plans

    Check out dozens of free project plans for tablesaw accessories and jigs at

    Free Videos

    Watch free related videos from the WOOD® magazine staff by visiting, and then scroll down to the "Tools Tips & Techniques" category.

Read more about

Tip of the Day

Fuzz buster

shop tip

How many times have you smoothly finished new wood, only to have the grain raised by stain, paint,... read more