Yes, you can make cabinet-quality cuts with this much-maligned tool, by using these can't-miss tips.
saw blade

Start with the right blade

Replace the 24-tooth blade that came with the saw with a 50- to 60-tooth blade for cleaner crosscuts in solid wood, veneered plywood, and other sheet goods. For general use when cut quality isn't critical, use a 40-tooth blade. If you're ripping solid wood, switch back to the 24-tooth blade.

Beat tear-out in 3 ways

Because a circular-saw blade cuts on an upward rotation, the bottom face, in which the teeth enter the cut, will almost always have a clean, tear-out-free surface. Meanwhile, the top face suffers tear-out so bad it cannot be used in a visible area on a project. (See the three photos at below for different degrees of grain tear-out.) So whenever possible, put the best face down when cutting. When you must cut with the best face up, use one of these tips to make your workpiece edges look like the one in the best photo.

Bad 102061771.jpg
An unsupported cut incurs bad tear-out.
Better 102061772.jpg
Covering the top face with masking tape helps.
Good 102061770.jpg
Clean cuts like this make projects look best.

Score the cutline first

Make your cut in two passes instead of one. A shallow scoring pass cleanly shears the surface fibers rather than lifting them upward.

Make a scoring pass about 1/8"deep by lowering your saw's footplate.When done, raise the footplate andmake the through cut.

Set clearance to zero

To support the wood fibers, especially plywood's thin veneers, where the blade exits the workpiece, attach an auxiliary subplate to your saw's footplate (also called a base or shoe). When you plunge-cut through this extra layer, you'll create a zero-clearance opening around the blade to eliminate tear-out.

CAUTION: Be extra careful when using a saw this way because the blade guard cannot cover the blade below the auxiliary footplate.

Attach a 1/4"-thick hardboard or MDFauxiliary subplate to your saw'sfootplate with countersunk machinescrews. Plunge the blade throughthe blank for zero clearance.

Make your own guide

A custom edge guide for your saw not only beats tear-out, but also makes it easy to align cuts. Start by building a jig based on the drawing below; adjust the width as needed for your saw. We made ours long enough for crosscuts in 4'-wide sheet goods. Make the base's cutting side about 12 " wider than the distance between your saw's blade and the footplate edge below the motor. Trim the guide to custom-fit your saw by running the footplate against the fence to create the zero-clearance support. Clamp the jig on the "keeper" piece when cutting because the jig does not provide zero-clearance for the cutoff.

After cutting the guide to matchyour saw, clamp that edge directlyon your layout marks. Then cut whileholding the saw against the fence.

Prevent splintered cutoffs

If you crosscut solid wood or plywood without supporting both the keeper piece and the cutoff, you'll frequently get a splintery tear-out along the far edge when the cutoff drops away before you've finished the cut. To avoid this, dedicate two inexpensive boards as "sacrificial" supports, set in place on sawhorses or your workbench top.

Sacrificial supports.jpg
When crosscutting a board, place iton a pair of 2x4s. Then, with theblade set to cut slightly into thesupports, cut your workpiece to length.