You are here

This drill-press jig holds steady for angled drilling

When restoring a set of dining room chairs, I needed to replace a leg rail that required drilling angled dowel holes into the end of the new rail. This jig made drilling the holes a breeze. Make the radiused slot in the jig’s face using a router trammel. This makes it possible to adjust the jig’s upright to the exact angle you need.    
—Joe Stoltz, Springfield, Va.

 

Read more about

Tip of the Day

Put the Squeeze on Curved-Profile Edges

The flat face of a clamp will press evenly against a square piece of edging. But when you need to... read more