You are here

Shave a whisker with this simple belt-sander jig

When needing to take off just a little material from a piece of trim that has a mitered or 90° edge, use this simple jig, modeled after a Speed Square. Hold the jig tightly against the edge of the belt sander’s table during use. Or if your sander has a miter slot, build the jig with a runner to fit the slot.
—Dan Martin, Galena, Ohio

Read more about

Tip of the Day

No-rock, easy-roll planer outfeed conveyer

My benchtop planer used to snipe until I came up with this inexpensive outfeed support that rests... read more