You are here

Shave a whisker with this simple belt-sander jig

When needing to take off just a little material from a piece of trim that has a mitered or 90° edge, use this simple jig, modeled after a rafter square. Secure the jig tightly against the edge of the belt sander’s table during use. Or if your sander has a miter slot, build the jig with a runner to fit the slot. 
—Dan Martin, Galena, Ohio

 

Read more about

Tip of the Day

Saw fence rubdown sharpens knives quickly

I know the importance of keeping sharp knives in my jointer, but found honing them a pain. Here’s... read more