Tools and Reviews
Here you'll learn how to use power tools and hand tools to full advantage in your woodworking shop. These include the table saw, jointer, bandsaw, mitersaw, CNC machine and others.
I recently bought a new belt sander and new belts. Four of those, fractured at the seam. Could heat and humidity cause these failures?
Every time I use a dado set to cut half-lap joints, I seem to waste a lot of time lining up each successive cut to the edge of the blade. Is there a faster system?
I’m building a triangle and need to cut 60° bevels. My tablesaw, compound mitersaw, or portable circular saw are limited to 45° cuts. Can you please explain how to do it?
While routing diagonal to the grain of a workpiece the corner breaks off. Should I step up from a 1⁄2 " to a 3⁄4 " pattern bit?
I purchased a Bosch 4000 benchtop tablesaw and wanted to buy a dado blade for it. A store owner said that a dado blade was unsafe for a benchtop tablesaw. Do you agree?
On my pneumatic tools, I installed an air dryer to remove moisture and fine particles. Am I doing right by drying my air?