Incra Miter 5000 miter sled

WOOD magazine rating
Miter 5000


The Miter 5000 blends the incremental angle control features of the Miter 3000SE with a very special 3-panel Sled for the ultimate miter cutting workstation for the table saw.

A Renewable Right Panel provides zero-clearance tear-out control and cut-off support on Both sides of the blade. Two aluminum T-tracks are embedded in the MDF panel top to secure an included work piece hold-down clamp and to provide absolute rigid support for the 36" to 64" telescoping IncraLOCK Cut-off Fence. Will crosscut a 25" wide board with full control on a standard 10" table saw. The Miter5000 by INCRA delivers perfect, repeatable accuracy.

First time, Every time, Any angle.

INCRA Hold Down Clamp
Included with every Miter 5000 is this simple and incredibly useful Hold Down Clamp which locks your workpiece onto the sled for maximum accuracy and the cleanest cuts possible. It only takes seconds to use and provides the rigidity needed for world class results.

GlideLOCK Miter Bar
The expansion disks adjust both sides of the bar for ZERO side play, anti-friction travel on all table saws with standard 3/4" x 3/8" or near-standard miter gauge channels, including Delta, Craftsman, imports, etc. The miter bar's adjustment range accommodates actual slot widths between 0.740" and 0.760".

Special Edition Telescoping
This Special Edition Miter Fence telescopes from 36" to a full 64" length. Includes the Dual Flip Shop Stop and INCRA's patented Automatic Positioning Control.

AngleLOCK Indexing
Precision angle indexing teeth are laser cut in solid steel to lock in 364 positive angle stops in 1/2°, 1° or 5° increments over a full 180° range. it's also continuously adjustable between 1/2° steps.

INCRA Miter 5000 Features:
364 Positive Stop in 1/2° Increments
Extender Fence Telescopes from 36" to 64"
GlideLOCK Miter Bar Adjusts to Fit Any Standard Table Saw
INCRA Flip Shop Stop Positioner
Indexing Every 1/2° Plus Continuous Adjustment Between
Right- and Left-tilt saw compatible
Fence lock down clamp for rock solid support
Miter Slider included for static sled panel positioning

WOOD magazine review

Great accuracy, but heavy and sometimes awkward

Review Summary

High points: This sled uses Incra’s Miter 3000SE head assembly, and shares its high and low points. It also has a 36"-long fence with the same flip-stop that extends to 68". After cutting to fit your saw, the nonsliding cutoff platform helps keep workpiece cutoffs from dropping into the blade and ejecting toward you. Low points: This is the only sled that did not include nylon glide strips for easier sliding on the saw top.
As a result, the Miter 5000 frequently caught on the edge of our saw’s outfeed table. The included hold-down clamp sometimes pulled workpieces away from the fence when tightening. At just under 24" square and weighing just over 24 lbs, this sled can be a chore to lift and use. More points: You can turn the fence enough to make tapered rip cuts, but clamping workpieces securely in this setup requires at least one extra clamp.

Detailed Ratings

out of 5





Ease of Use




Tip of the Day

Tiny plugs make nail holes nearly invisible

From a piece of scrap that matches your work stock, use leather hole punches to cut tiny plugs to... read more