Miter-gauge Extension

December/January 2011/2012 Issue 209 Page: 28 Number of Pages: 2.00

Plan is available at the WOOD Store and on complete collection USB Drive

Category

Corrections

Page 30 - The Body/Extendable Stop has drawing corrections, see Sounding Board, Issue 213 September 2012, page 6 for corrections. Page 30 - For machining the 5/8" T-slots along the back and top edges of the body/extendable stop, we started by cutting a 3/8" dado 7/16" deep. Then, we used the Rockler T-Slot Cutter router bit (part no. 26099) to rout the slots in the edges of the dadoes. If you don't have such a bit, you could also create each T-slot by cutting a 5/8" dado 7/16" deep and glue two 1/4"-wide strips 1/8" thick in place to create the T-slot in each dado. Change Drawing Body/Extendable Stop T-slot measurements 1/8" to 3/16" and 1/2" to 5/8". See Sounding Board issue 213, page 6.