Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Screws & Fasteners

Pages in this Story:
More about Fasteners

More about Fasteners

Sorting Out Screw SizesCompared to other materials and fasteners, screw sizes are a breeze to figure out. Their gauge refers to shank diameter in a range from 0 (the smallest) to 24 (the largest). Gauge increases by .013", or about 1/64", in each increment. Screw lengths begin at 1/4" and reach 4" or longer, though you'll probably stay in the middle range in your home woodworking.

To cover all possible applications, each length comes in three or more diameters. As a rule, the smaller the gauge of the screw, the thinner the wood you should use it in.

Head Styles You Can Drive Home Different screw-head styles suit a divergence of woodworking needs and requirements. (See drawings shown on the opening page of this section.)

Choose flathead screws for general assembly, where you will countersink or counterbore the screw before covering with putty or plugs. When a flush surface isn't important, or when you want a decorative effect, roundhead screws fill the bill.

You use ovalhead screws primarily to install hardware, such as cabinet hinges, because their shape matches the machined hole snugly.

Besides differing head styles, screws also come in choices of drive slots to match your tools (again, refer to the drawings on the opening page of this section).


How to Buy Screws

Wood screws generally are sold by the box; those 4" and shorter packed in quantities of 100. Screws over 4" come in boxes containing 25 or 50, depending on their gauge and length. Most hardware dealers, of course, let you buy less than a box, but the individual price goes up.

To order wood screws from your hardware dealer or mail-order supplier, you must specify the type of head, type of slot, length, diameter (gauge), material, and finish. Abbreviations, such as FH, RH, OH, refer to flathead, roundhead, and ovalhead screws.



The Pilot Hole: Tight, But Not Too Tight

Think of a pilot hole as a custom-fitted binocular or gun case. As you can see in the drawing, it grips every contour of the screw, allowing the threads to bite and hold in the wood.When you drill a pilot hole, you're guided by the screw's dimensions: its length, the diameter of its shank, pilot (less threads), and head (for countersinking, or counterboring, if a plug will be used).

The easiest way to accomplish this is with a screw pilot, which drills all parts and configurations of the hole in one operation.


A Few Points on Nails

Finishing nails are thin, small-headed nails for installing molding and other interior trim. Usually you countersink the head and fill the hole with putty to make it invisible. When the smallest nails are too large, use wire nails, which have flat heads, and brads, with heads like finishing nails. Sizes designate the length and gauge.


 

close


Comments (0)
8046223372

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
more smart savings
  • Recent Posts
  • Top Posts
See More >