Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Dealing with wood defects

Pages in this Story:
Twist Defect
twistdefect
Enlarge Image
 
Twist: A board that rests
on opposite diagonal
corners when laid on
one face.

Twist Defect

Solution: A severely twisted board is difficult to save. You may salvage short pieces, though, by using a combination of the methods described on previous pages.


Continued on page 6:  Checks, Shakes, and Knots

 

close


Comments (4)
8484574509
Phellis wrote:

I had a few pieces of Oak that were crooked and my solution, due to limited space and tools, was to align and clamp the board with the outside crook parallel to the edge of my workbench then use a HD trim bit in my router to straighten the crook. Then I ran the routed edge through my joiner and finally used this straight edge to guide the board through my table saw to trim the inside crook off for a nice straight board.

11/6/2014 11:13:01 AM Report Abuse
dhellew21 wrote:

There is nothing wrong with knots. Knots and the grain around them add character and color to the wood. Small knots can be glued in place with super glue, larger ones with gorilla glue before processing the wood.

11/6/2014 10:34:42 AM Report Abuse
pf2 wrote:

The other day, I needed to clean up rough edges on 4' boards. Rather than use a carrier strip requiring extra steps to install/remove double-sided tape, I clamped an 8' length of 2"x2" angle aluminum onto my fence over a 1/4" spacer to lift it off the table saw slightly. This gave me an 8' long fence that the rough boards could ride against... a charm. Quick work of all the boards -- even with resetting the fence position for different board widths.

11/22/2013 10:23:49 AM Report Abuse
RickGarrett wrote:

maybe the artical is short, but truth be known. This is some realy good info. @least for me.

1/20/2011 06:44:01 PM Report Abuse

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
  • Recent Posts
  • Top Posts
See More >