Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now

Sand for a perfect finish

Pages in this Story:
Start smooth to end smooth

Start smooth to end smooth

After finish-sanding the bare wood of your project, typically to 220 grit, vacuum the surface to remove embedded dust; then, wipe the surface with a clean rag dipped in mineral spirits. Allow the surface to dry thoroughly.

Apply the first coat of finish to your project and let it dry completely. In a well-lit area, buff out the first coat with 220-grit stearated (abrasive loaded with a dry lubricant) or open-coat (half the amount of abrasive grain leaves room for the loading of material) abrasive. Use long, straight strokes parallel to the grain, applying light, even pressure and overlapping each stroke. The finish can rub through to bare wood most easily on the edges of the workpiece, so ease up on your pressure when sanding these areas.

After making a complete pass with the abrasive, wipe down the workpiece with a clean rag and feel for smoothness. Your finish will appear dull or slightly scratched after sanding, but the next coat of finish will restore its luster. Buff out the second coat like the first, using 320-grit paper, then recoat and repeat, ending with 800 grit.

Continued on page 2:  Real (and unreal) steel does the trick


Comments (0)

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."


Connect With Us
  • Recent Posts
  • Top Posts
See More >