Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Stay on Guard Against Kickback

Simple strategies help you play it safe.

Pages in this Story:
Kickback causes and strategies

Kickback causes and strategies

All spinning saws can kick back. And, boy, does it happen quickly! To protect yourself, learn the causes of kickback, and counter them with safe work habits. You'll reduce the chances of kickback happening-and if it does, you'll be out of harm's way.


What causes kickback?

Pinching is the most common culprit. If the saw kerf closes in on the blade so that it can't spin freely, something has to give. Depending on what kind of tablesaw you're using, either the tool jumps or the wood flies in the direction of the saw blade's rotation.

On a tablesaw, the wood's direction is straight back at you. On a radial-arm saw, it's straight at you when ripping and away from you when crosscutting. When using a handheld circular saw or a chainsaw, the saw itself can leap toward you.


kickback
Enlarge Image
 
This is the way to play defense against tablesaw kickback. Stand at the outside edge of the board, use a proper pushstick and feather board, and keep your anti-kickback pawls and splitter in place.
Stationary saw safety strategies

Always stand slightly to the outside edge of the board when you're ripping on a tablesaw. That keeps you out of the direct line of kickback. If you're feeding the workpiece by hand, your hand can slip forward toward the blade when the board kicks out. So use a pushstick made of soft plastic, or a properly shaped piece of wood, and keep it out of the blade's path. Don't pull the workpiece from the back side of the tablesaw-a kickback can yank your hand right into the blade.

To avoid tablesaw kickback, keep the kerf open with a splitter-either a commercial version or one built into a homemade table insert. Most tablesaws also come with anti-kickback pawls, those metal teeth that prevent the workpiece from sliding backward. Keep them installed on the saw. Make sure each piece of wood, whether it's a long board, wide sheet, or something in between, has adequate support all the way through the saw blade. When making a bevel cut, keep your miter gauge or pushstick on the opposite side of the blade's high point.

When you're using a radial-arm saw, again, don't stand in line with the board when ripping. Keep your hands out of the line of cut at the infeed side, and don't reach around the blade.


Continued on page 2:  Be patient with portable saws

 

close


Comments (0)
7942996021

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
more smart savings
  • Recent Posts
  • Top Posts
See More >