You are here

Make a Safe and Easy Pushblock for Your Table Router

pushblock

To keep fingers safely away from your bit when routing, use a pushblock, as shown at right. You easily can make your own from a 3/4" x 4" x 4" piece of medium-density fiberboard and a 4" length of 1/2" dowel glued into a hole drilled in the center of
the block. Other benefits: The pushblock lets you easily guide the workpiece while keeping it tight against the fence. It also
serves as a backer to avoid chip-out.

pushblock
Read more about

Tip of the Day

Pick the best tape for every job

Choosing the right tape is as important as choosing the right tool. Here is one of our favorite... read more

Talk in General Woodworking