Special Offer!

2 FULL YEARS + FREE GIFT! Order NOW and get 2 FULL YEARS of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for just $30. This is a limited-time offer, so HURRY! (U.S. orders only) (Click here for Canadian orders)


Email:
First Name:
Last Name:
Address:
City:
State:		Zip:

100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.

Close [x]

Help

Round-over bits basics

Share
Print
Comments (0)

4 of 9

Set up a round-over bit

After mounting a round-over bit in a router, adjust the bit up or down so the bottom of the concave cutting edge aligns flush with the router base or the surface of the router table. Use a flat block of wood, as shown in the drawing, to check your adjustment.

Before cutting your workpiece, test the cut on scrap stock. If the bit extends too far, it will cut a slight ridge into the workpiece surface, called a fillet. If the bit does not extend far enough, it will cut an incomplete radius.

11 Ways to Get the Most from Your Router