Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Making Box Joints

Before the advent of cardboard boxes, manufacturers joined the sides of thin wooden boxes with these joints because they were strong and fast to make. Today, box joints have taken on practical and decorative roles in projects ranging from jewelry cases to hope chests. After you build the jig featured in the Box-Joint Jig Project, follow these steps and see firsthand how easily you can master this joinery method.

Pages in this Story:
Page1

Page1

1. Before you cut the actual box joints, keep in mind that the width of your box sides must be an increment of the finger width. Otherwise, you'll wind up with less-than-pleasing partial fingers at the bottom of your box. So, in the example of 1/4"-thick stock discussed here and in the jig-building article, the width of the workpieces must be an increment of 1/4" (such as 5", 51/4", 51/2", etc.).


a_109_1_2

2. Mark the front, back, and side pieces of your box. Also, mark the top edge on each of these pieces.

For each box you make, you cut the sides consecutively, and the front and back consecutively. It doesn't matter which pair you do first, so we'll start with the sides.

For all of the following cuts, hold the top edge of the workpiece toward the jig pin for the first cut. Now, put hand pressure on the jig to hold its miter-gauge bar firmly against the right side of the tablesaw channel. Make the first cut as shown above. Place the just-cut notch over the jib pin and repeat to cut fingers along the full width of the workpiece. Cut the other side piece in the same fashion.


a_109_1_3

3. Before you cut the front and back, cut one notch into a scrap piece, just as you cut the first notch into the side piece earlier. Position this notch over the pin as shown at left, and butt the top edge of the front piece against the scrap before making a cut. Make the remaining cuts in the front piece by removing the scrap, placing the notch over the pin, and proceeding as described earlier. Cut the back piece just as you cut the front.


Continued on page 2:  Page 2

 

close


Comments (3)
8091187804
pjp16 wrote:

wood magazine subscriber need October 2014 issue FREE box joint plans.

8/12/2014 10:45:55 PM Report Abuse
gene_berens wrote:

how do I download box joint fixture?

3/13/2014 10:37:03 AM Report Abuse
grip wrote:

I have wanted a jig like this for some time. I will have soon now. Thanks Wood magazine.

12/11/2010 04:06:18 AM Report Abuse

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
more smart savings
  • Recent Posts
  • Top Posts
See More >