Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Haunched Tenons

Pages in this Story:
Move the rip fence

Move the rip fence

Move the rip fence 1/4" closer to the dado set and lock it in place. Place the rail against the miter gauge with the grooved edge up. Make a series of passes to form the haunched shoulder of the tenon. You should be able to butt the end of the workpiece against the rip fence for the final pass, but test the fit before making that pass.


Continued on page 5:  Test the joint's fit

 

close


Comments (3)
8174347783
jbe1932 wrote:

To get the complete article printed together to take to the shop, just "copy" on each section and paste each of them into a single document in your word processor and then print your new document.

6/11/2010 03:09:55 PM Report Abuse
jbe1932 wrote:

The next page selection only applies to the comments. The additional pages of the article are list at the top where it says "pages in this story". This is different but easy to figure out.

6/11/2010 03:04:15 PM Report Abuse
mrtilly wrote:

To get hard copies just pick the page you want and press the "PRTSC" or (print screen). Then open a word document and "Paste". The page should appear and then you can "crop" it and resize. Press "enter" to move down one line. Add the next page in like manner.

6/11/2010 12:21:17 PM Report Abuse

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
more smart savings
  • Recent Posts
  • Top Posts
See More >