Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Haunched Tenons

Pages in this Story:
Mount a dado set

Mount a dado set

Mount a dado set on your tablesaw and raise its height to 1/4". Make a test cut on both faces of a scrap piece, and test the fit in one of your mortises. Set your rip fence so that the distance from the fence to the left side of the dado set equals the depth of the mortise as measured from the stile edge, minus 1/16". With an auxiliary fence on your miter gauge, make passes on each face to form the tenon.


Continued on page 4:  Move the rip fence

 

close


Comments (3)
8598902381
jbe1932 wrote:

To get the complete article printed together to take to the shop, just "copy" on each section and paste each of them into a single document in your word processor and then print your new document.

6/11/2010 03:09:55 PM Report Abuse
jbe1932 wrote:

The next page selection only applies to the comments. The additional pages of the article are list at the top where it says "pages in this story". This is different but easy to figure out.

6/11/2010 03:04:15 PM Report Abuse
mrtilly wrote:

To get hard copies just pick the page you want and press the "PRTSC" or (print screen). Then open a word document and "Paste". The page should appear and then you can "crop" it and resize. Press "enter" to move down one line. Add the next page in like manner.

6/11/2010 12:21:17 PM Report Abuse

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
  • Recent Posts
  • Top Posts
See More >