Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now

Half-lap joints

Making a half-lap T-join

Making a half-lap T-join

Sometimes, you may have to place a half-lap joint somewhere other than at the end of a workpiece. Then, follow these two easy steps.

First, mark the position of the overlap onto the edge of the workpiece that will be cut in its midsection as shown in illustration below right. For accuracy use a sharp pencil.

Continued on page 7:  Cut the T-joint


Comments (5)
blurover wrote:

I believe mmyjak has a good point. You should us a short stop block against the fence that allows the work piece to clear before the cut begins. Also, the method described by berowen uses much less material.

9/2/2012 07:57:04 AM Report Abuse
wdworker509644 wrote:

Miter gauge can be used safely IF the cut is not all the way through the stock.

7/21/2012 05:43:39 PM Report Abuse
kerrygmo wrote:

Berowen, thanks for that tip. That's as easy as it gets.

7/19/2012 10:41:18 PM Report Abuse
mmyjak wrote:

I don't like to advocate using the Miter Gauge in conjunction with the Rip Fence. Rather then instill a potentially bad habit, its just as easy to use a gauge block clamped to the rip fence.

5/4/2012 08:33:23 AM Report Abuse
berowen wrote:

Alternative method for setting depth is to use a scrap piece that is the same thickness as your project wood. Raise your blade to just under 1/2 the stock thickness (eyeballing will do). Make a test cut, flip the piece, make another cut. Bump up the blade height again and repeat the two cuts until the left over sliver of wood just disappears. You should now have a perfectly set blade height.

5/3/2012 10:34:22 AM Report Abuse

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."


Connect With Us
  • Recent Posts
  • Top Posts
See More >