Help

Half-lap joints

Share
Print
Comments (5)

Pages in this Story:

Step 4: Clamping comes next

Step 4: Clamping comes next

To clamp the joint, first apply wood glue to all mating surfaces. Draw the workpieces together with bar or pipe clamps. Then, bring the glued surfaces tightly together with a small clamp. Place a scrap of wood on the joint faces to protect them from the clamp jaws.

Continued on page 6: Making a half-lap T-join

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY! (U.S. orders only) (Click here for Canadian orders)

First Name:

Last Name:

Address:

City:

State:

Zip Code:

Email Address:

100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.

Comments (5)

blurover wrote:

I believe mmyjak has a good point. You should us a short stop block against the fence that allows the work piece to clear before the cut begins. Also, the method described by berowen uses much less material.

9/2/2012 07:57:04 AM Report Abuse

wdworker509644 wrote:

Miter gauge can be used safely IF the cut is not all the way through the stock.

7/21/2012 05:43:39 PM Report Abuse

kerrygmo wrote:

Berowen, thanks for that tip. That's as easy as it gets.

7/19/2012 10:41:18 PM Report Abuse

mmyjak wrote:

I don't like to advocate using the Miter Gauge in conjunction with the Rip Fence. Rather then instill a potentially bad habit, its just as easy to use a gauge block clamped to the rip fence.

5/4/2012 08:33:23 AM Report Abuse

berowen wrote:

Alternative method for setting depth is to use a scrap piece that is the same thickness as your project wood. Raise your blade to just under 1/2 the stock thickness (eyeballing will do). Make a test cut, flip the piece, make another cut. Bump up the blade height again and repeat the two cuts until the left over sliver of wood just disappears. You should now have a perfectly set blade height.

5/3/2012 10:34:22 AM Report Abuse