Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Break free from biscuit blunders

2 of 9
Mistake #1: Exposed biscuit slots

Mistake #1: Exposed biscuit slots

Cutting through the face of a workpiece's beveled end, as shown at top left, causes damage nearly impossible to repair. This goof happens when you cut a slot for a large (#20) biscuit at the midpoint of the bevel in 3/4"-thick stock.

Solution: Avoid this mistake by cutting the slot closer to the inside corner of the beveled end. To do this, adjust your joiner's fence, as shown middle and below. This allows you to still use a #20 biscuit without cutting through the face. (You should always use the largest biscuit possible for maximum holding power.)

Download PDF of photos

Twelve Ways to Get the Best from Your Biscuit Joiner

2 of 9


Comments (0)
8225914474

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 
 
more smart savings
Connect With Us
  • Recent Posts
  • Top Posts
See More >