Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Drill dead-on dowel joints

Pages in this Story:
Vertical misalignment

Vertical misalignment

Problem: My edge-to-edge joint fits together, but the faces are not flush.

Solution: The jig's guide holes may not be centered between its faces. Always reference the jig against common faces of each mating piece (shown right). Do so, and though the holes may not center in the boards' thickness, they will line up.


Continued on page 3:  Horizontal misalignment

 

close


Comments (1)
8320458424
jgensic1 wrote:

I am a beginner. This was simple, clear, and will make this process doable with better quality.

11/5/2013 02:04:46 PM Report Abuse

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
  • Recent Posts
  • Top Posts
See More >