Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Trim edge banding, the sequel

A notched spacer for proven results

Simple setup for trimming the ends off banded pieces

Simple setup for trimming the ends off banded pieces

A shop-tested technique to flush-trim the excess length from solid-wood edge banding. Cut a notch just a whisker wider than your saw blade in a piece of scrapwood spacer, as shown. Again, position your fence so that the outside edge of the spacer is flush with the outside of the blade, and make a test cut. Finally, trim off the end of the banding.


If you like this project, please check out more than 1,000 shop-proven paper and downloadable woodworking project plans in the WOOD Store.


 

close


Comments (0)
8484873214

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
  • Recent Posts
  • Top Posts
See More >