Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Pivoting casters for stability and smooth travel

When designing a mobile base for my tablesaw and its extension table, I was concerned about how a four-wheeled base might twist and rack as the large, heavy saw moved across my uneven garage floor. Using the principle that any three points in space form a plane (like a tripod), I built a frame that includes both a triangular plane for stability and four casters for better weight distribution on the casters.

To create the tripod effect, I installed two fixed casters on the base at the heavy end of the saw to form the first two points of the triangle. For the third point, I built the pivot arm, shown below, and attached it to the base with a 1/2x5" bolt, washers, and nuts.

As the base rolls across the uneven floor, the two casters on the pivot arm are free to pivot up and down to conform to the floor, with the bolt acting as a pivot point. Yet, in use, the stand is as stable as any three-point wheelbase.

Gordon Hofer, Santee, Calif.


If you like this project, please check out more than 1,000 shop-proven paper and downloadable woodworking project plans in the WOOD Store.


 

close


Comments (1)
7525931422
Tom Harrington wrote:

I've been pondering how to solve a similar problem with my Powermatic 2000 table saw, which has built-in casters under the saw itself but only fixed legs for the extension table. These pivoting casters are the perfect solution--thanks!

2/16/2010 08:08:57 AM Report Abuse

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
more smart savings
  • Recent Posts
  • Top Posts
See More >