Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Panel-Cutting Sled

Panel-Cutting Sled
Enlarge Image
 

Panel-Cutting Sled

When you use our panel cutting sled, you'll never wonder if the corner you just cut is square. For hair-splitting accuracy, the beefy fence is fixed at 900 to the blade and shows exactly where your saw blade will cut. And, the fence-leading design holds wider workpieces more solidly and keeps your work closer than fence-trailing jigs.



When you use our panel cutting sled, you'll never wonder if the corner you just cut is square. For hair-splitting accuracy, the beefy fence is fixed at 90 to the blade and shows exactly where your saw blade will cut. And, the fence-leading design holds wider workpieces more solidly and keeps your work closer than fence-trailing jigs. Build the jig according to the drawing above and the Stop detail at left. We made ours from birch-veneer plywood with a solid poplar fence, but you could use any 1/2" plywood or medium-density fiberboard and a straight scrap of 2x4. Cut both pieces 1/8" longer than shown; you'll trim them to their exact length after you build the jig. Note: A well-tuned tablesaw is essential to complete the assembly. Your saw blade must be perfectly parallel to the miter slot. If the instructions for your tablesaw are not clear on how to do this, consider the downloadable seminar, Tuning Up Your Power Tools Part 2, being sold in the WOOD STORE. Beforeattaching the miter-slot bar, ensure the corner formed by the fence and the right edge of the sled is square. Make a mark 3" from the corner along one edge, and 4" along the perpendicular edge. Measure diagonally between the two marks. If the diagonal measures exactly 5", your corner is square. If it's more than 5", the angle is greater than 90; less than 5", and it's less than 90. Next, measure the distance between your tablesaw's blade and miter slot and add 1/8". Using that measurement and a combination square, scribe a line on the bottom of the sled, measuring from the saw blade edge. Attach the miter-slot bar along the scribed line. With the sled's guide bar in your tablesaw's miter-gauge slot, crank the saw blade up to full height. Run the sled through the blade, slicing off the extra 1/8" from both the base and the fence. You now can cut with confidence by aligning the cut line on your workpiece with the edge of the fence. For repetitive cuts less than 27", clamp a stop block to the fence. When cutting pieces up to 48", lock in the sled's built-in stop block.


If you like this project, please check out our 230+ paper and downloadable woodworking project below.


 

close


Comments (0)
7520976229

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
more smart savings
  • Recent Posts
  • Top Posts
See More >