Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Joinery routing guide

Pages in this Story:
Two cuts rout a rabbit

Two cuts rout a rabbit

Put your new jig to work

For routing dadoes, rabbets, and half-laps, mark a joint edge and waste area on your workpiece, as shown in the photo, and set your bit depth. For dadoes, align the workpiece mark with the fence dadoes, clamp the workpiece in position, and rout one pass against each guide.


Continued on page 4:  Rout rabbets, dadoes, and half laps with ease

 

close


Comments (1)
7950039222
whkendri wrote:

I like it

10/4/2012 06:02:54 PM Report Abuse

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
more smart savings
  • Recent Posts
  • Top Posts
See More >