Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Hinge Location Jig

Pages in this Story:
Page 2

Page 2

Stick a large piece of double-faced tape to each installed index block. Now, hook one of the rail's stopblocks on the door's top edge, and press the rail onto the index blocks, as shown below. Keep the rail's back edge and the index blocks' back edges flush.


313_2_2

To make the jig usable on both right- and left-handed doors, align a second set of index blocks with the first, sandwiching the rail between them, as below. Carefully remove the rail and attached blocks from the door. Drive 1/2" wire brads from both sides to lock the squares in place.

Hooking one stopblock on each door's top edge, use the jig to locate the hinges on the rest of the doors. Drill the hinge screw pilot holes.


313_2_3

Once again, hook the jig's stopblock on a door's top edge. Mark and trim the rail to extend 1/16" beyond the door's bottom, as shown here. This extra 1/16" is the gap between the door and the carcase. Mark the jig's top end. Remove the stopblocks by cutting the rail just above the top index blocks, as shown.


hingejig6

Now the jig is ready to position the hinges in the carcase. Simply place the jig against the inside of the cabinet with the rail's marked end up, as shown at right. Clamp or use double-faced tape to hold the jig in place. The index blocks bracket the hinges, just as they did on the doors. Position the hinges between the index blocks, and drill the screw pilot holes.


If you like this project, please check out more than 1,000 shop-proven paper and downloadable woodworking project plans in the WOOD Store.


 

close


Comments (0)
8334506965

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
  • Recent Posts
  • Top Posts
See More >