Drill-Press Dust Collector
Airborne debris doesn't stand a chance with this device.
Drill-Press Dust Collector
Wood chips and sawdust don t stay around long when you hook up this clamp-down collector to your shop vacuum or dust-collection system. You ll breathe a lot easier, and cut down cleanup time, too. Use the Exploded View drawing to construct the collector from 1/4" plywood and 3/4" stock. Cut or sand 10° bevels across the top and sides of the 3/4"-thick back, where shown below. To reduce sawdust buildup at table level, sand a bevel across the front edge of the bottom piece.
If you like this project, please check out more than 1,000 shop-proven paper and downloadable woodworking project plans in the WOOD Store.
Drill Press Dust Collector Plan
To learn more about dust collection solutions visit the Dust Collection Section in the WOOD Store.
Add your comment
Please confirm your comment by answering the question below and clicking "Submit Comment."
It would sure be nice to be able to print this or see the other views.
6/27/2012 01:01:43 PM Report AbuseI like it! Simple is good. I changed materials to clear 1/4 in. Plastic, just what I needed. Thank You.
11/24/2009 06:22:02 PM Report Abuse