Turn a Bernson Showcase Vase
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY!
(U.S. orders only) (Click here for Canadian orders)

Email:

First Name:

Last Name:

Address:

City:

State:

Zip:

100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.
Wood Magazine

Turn a Bernson Showcase Vase

A test-tube insert enables this beauty to hold fresh-cut flowers

Bruce Bernson, a self-taught woodturner, lives near the beautiful coastal city of Santa Barbara, California. He has been known to search as far as Oregon for uniquely grained woods, such as wild lilac and buckeye burl, for his turnings. He's even found some turning "treasures" in such unlikely spots as land-clearing sites and along the seacoast after storms.

Bruce turned the vase shown at right from a big-leaf maple burl dried in his own kiln (built from a 2,000-gallon gas tank).

Here's how Bruce turns this vase: "I start with a cube of wood approximately 4-1/2" square. I bandsaw the block to a cylindrical shape and mount the block between centers. Next, I turn it round, and remove stock from the ends to form two dowel-like supports."


Bruce uses a 1/2" roundnose scraper to form the sweeping neck and bulbous body. (See the drawing below right.)

To finish the vase, this craftsman turns it as smooth as possible on the lathe, and hand-sands it, using as fine as 600-grit paper. He then removes the turning from the lathe, cuts off the dowel-like projections, and drills a 9/16" hole 3" deep in the center of the top for a test tube.


As Bruce explains, "I apply a single coat of Watco Danish Oil to the vase and allow it to dry for three days." Still not satisfied, Bruce then applies tripoli to a 10"-diameter cotton pad mounted to an arbor, and hand-holds the vase against the spinning pad to buff it. At a point where most people would call it quits, Bruce proceeds to use a lamb's-wool bonnet mounted to another arbor, and applies a coat of pure carnuba wax to the burl vase.

"Finally," Bruce concludes, "I use white glue to adhere a piece of protective leather to the bottom of the vase. After the glue has dried, I trim away the excess leather with a sharp utility razor blade. I then sign and number the vase in the wood along the leather base with a woodburning tool."


Photograph: Bob Calmer; Dan Olmstad Illustrations: Kim Downing


Vase

If you like this project, please check out more than 1,000 shop-proven paper and downloadable woodworking project plans in the WOOD Store.


 

shim

Wood Magazine