Bore Vertical holes with scrap stock jig
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY!
(U.S. orders only) (Click here for Canadian orders)

Email:

First Name:

Last Name:

Address:

City:

State:

Zip:

100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.
Wood Magazine

Bore Vertical holes with scrap stock jig

Here's a quick-fix jig that will come in handy the next time you need to bore a vertical hole in the end of a long workpiece. To make the clamp block, laminate two 2x4s, one 9" long and the other 17" long, as shown in the drawing below. Then, joint the sides that face the workpiece and the drill-press table to achieve a perfect 90 angle.

Next, joint the edges and faces of the 1-1/2x2x10" fence to perfect 90 angles. Use a framing square to align the two pieces at 90. Then, fasten the fence to the clamp block with glue and four #8x2-1/2" flathead wood screws, and adhere a piece of 150-grit sandpaper to the clamp block as shown. Now, clamp the jig to the drill-press table, clamp the workpiece to the jig, and you're ready to bore your hole.


E. C. Peters, Brighton, Ont.


Bore holes

If you like this project, please check out more than 1,000 shop-proven paper and downloadable woodworking project plans in the WOOD Store.


 

shim

Wood Magazine