3 rules for edge-joining with pipe clamps
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY!
(U.S. orders only) (Click here for Canadian orders)

Email:

First Name:

Last Name:

Address:

City:

State:

Zip:

100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.
Wood Magazine

3 rules for edge-joining with pipe clamps

1. Make sure the joints fit

Nothing can make ill-fitting joints close up tight. Before glueing, dry-fit all the joints. If you see "air," re-machine the edges.


2. Align your clamps correctly

Don't let the stock wander from your clamps' line of pull. That's the imaginary line running through the clamp's drive handle.


3 rules for edge-joining

Keep the line of pull parallel to the pipe. It seems simple, but there's one pitfall -- using the wrong size of clamps. The largest clamps, called 3/4" (the diameter of pipe they fit), have longer jaws. Use these clamps on stock 3/4" to 1" thick, the smaller on thinner stock. Otherwise, you'll have overpull or underpull, as shown below.


3 rules for edge-joining
3 rules for edge-joining

To use pipe clamps larger than the wood thickness insert spacers, as shown below. This brings the center of the wood up to the line of pull.


3 rules for edge-joining

Another technique is to "roll over" the larger clamps on the edge of the wood to compensate for their size, as shown below left.

To use smaller clamps on thick stock "double-clamp," as shown below right. Place one of the smaller clamps so that its line of pull centers in the stock just as a larger clamp would.


3 rules for edge-joining

3. Balance the clamps and never overtighten

Alternate clamps from side to side first on top, then bottom, working from the center toward both ends to even up the pressure.

Overtightening clamps will either bow or cup the workpiece. Or, the pipe itself will bend slightly.

Illustrations: Jim Stevenson


 

shim

Wood Magazine