Drill-Press Dust Collector
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Wood Magazine

Drill-Press Dust Collector

Airborne debris doesn't stand a chance with this device.

Drill-Press Dust Collector

Drill-Press Dust Collector

Wood chips and sawdust don t stay around long when you hook up this clamp-down collector to your shop vacuum or dust-collection system. You ll breathe a lot easier, and cut down cleanup time, too. Use the Exploded View drawing to construct the collector from 1/4" plywood and 3/4" stock. Cut or sand 10° bevels across the top and sides of the 3/4"-thick back, where shown below. To reduce sawdust buildup at table level, sand a bevel across the front edge of the bottom piece.


If you like this project, please check out more than 1,000 shop-proven paper and downloadable woodworking project plans in the WOOD Store.


 

shim

Wood Magazine