With a Router, You Need Direction
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY!
(U.S. orders only) (Click here for Canadian orders)

Email:

First Name:

Last Name:

Address:

City:

State:

Zip:

100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.
Wood Magazine

With a Router, You Need Direction

With a Router, You Need Direction

With a Router, You Need Direction

If you constantly wonder which way to feed your router into a workpiece, you better read this.

You know the rule when cutting stock on your tablesaw: "Always feed against the rotation of the blade." The same usually applies to your router, but it's not always clear which way that is. When edge routing, it's easy to see which way the router bit spins so that you can feed against its rotation. But what about routing a groove in the middle of a board? Or edge cuts in the middle of a workpiece? Then, even though the rule applies, it's not always easy to remember. Here are some simple guidelines to help you know which way to feed your router for any task.


Make a groove in the right direction

Routing a groove (a with-the-grain cut in the middle of a board or piece of plywood) in the wrong direction can be dangerous. The cutting action of the bit could pull the router out of control. And there's nowhere to hide when it happens-it's just too quick.

But here's an easy way to remember which way to feed for a groove. Looking down at the top of a hand-held router, the bit rotates clockwise, as shown in the drawing below left. With the router's edge guide fixed in position at 6 o'clock, feed toward 3 o'clock. The cutting action of the bit will try to move the router toward 12 o'clock. But this same action pulls the guide against the board, keeping the groove parallel to the edge of the board. If you rout grooves with a straightedge instead of an edge guide, clamp it to the workpiece at 12 o'clock. The router will run parallel to it for the very same reason.


Figuring out inside and outside edges

Routing outside edges and edges on the cutout in the middle of a workpiece isn't all that different from routing straight cuts. Imagine that the workpiece is a piece of toast with the buttered middle gone, as shown in the drawing, below right. Going around the workpiece on the outside, you feed your router counterclockwise. For the inside edge, feed the router clockwise.


Simple router-table safety

Featherboards add safety as well as accuracy when you rip on a tablesaw. Yet, they should be standard on your router table, too. So is a pushstick. That's because the router table enables you to do things you can't do with a hand-held router. But it also places your fingers nearer to the whirling bit, which you are normally feeding from the right side of the table. A featherboard and pushstick solve the problem by keeping the work firmly against the fence and table for a clean and safely done cut.


 

shim

Wood Magazine