Make flawless miters on your router table
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY!
(U.S. orders only) (Click here for Canadian orders)

Email:

First Name:

Last Name:

Address:

City:

State:

Zip:

100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.
Wood Magazine

Make flawless miters on your router table

For cutting miters in small project parts, nothing matches the dead-on accurate results of a router table equipped with a chamfer bit. Because the angle is machined into the bit rather than being set by eye, as on a mitersaw or tablesaw, there's no opportunity for error.

Begin by cutting your workpieces to final width and length. At the same time, also cut a plywood or MDF template to the same dimensions. (Because this technique calls for removing the flat edge of the workpiece, the template provides a surface to ride against the bit's bearing.) Double-face tape the template to the "good" face of the workpiece (right), keeping the ends and edges flush.

Adjust the router-table fence so it sits flush with the bit bearing, and the bit height to cut the full thickness of the workpiece, leaving the template untouched. With the help of a scrapwood backer block to keep the workpiece steady during machining, make the cut. Rotate the workpiece and cut the opposite end. Reuse the MDF template for identical pieces.

Note: If your router lacks the power to make a full-depth chamfer cut, make a template for each workpiece and cut all the workpieces at partial depth. Adjust the bit depth and cut all the parts again, creeping up to the final depth.

More Resources

  • Strengthen those miters with splines. See the jig at woodmagazine.com/splinejig
  • Find tons of router tips at woodmagazine.com/routingtips


 

shim

Wood Magazine