Changing bandsaw tires
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY!
(U.S. orders only) (Click here for Canadian orders)


First Name:

Last Name:





100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.
Wood Magazine

Changing bandsaw tires

You wouldn't dream of driving a car for years without checking its tires, so why do it with your bandsaw? To make a quick assessment, pop the bandsaw's hood, remove the blade, and inspect the tire for visible cracks or missing chunks. If there are any, it's time for a replacement. Here's how to do it.

Before installing a new tire, pry off the old one with a flathead screwdriver, or cut it off with a sharp utility knife. Scrape away old adhesive or remaining tire fragments with a putty knife, then remove any adhesive residue from the wheel using a rag and lacquer thinner.

As a final step, clean the wheel rim with denatured alcohol and allow it to dry thoroughly before mounting the new tire. You want a bare-metal surface for the tire to adhere to, and some solvents -- including lacquer thinner -- leave behind a residue that can reduce the adhesive's effectiveness.


Rubber tires: Stretch 'n' glue
Large bandsaw wheel
Enlarge Image
Stick under a belt
Enlarge Image
When applying the adhesive, roll
the pipe or rod away from the fresh
glue and apply more adhesive to the
newly exposed gap.

Rubber tires: Stretch 'n' glue

To install a rubber tire, slide part of the tire onto the wheel rim with the rough-sided surface of the tire against the rim. Clamp it with a small C-clamp and a 1/4"-thick piece of scrap. Stretch the tire to the wheel's opposite side; then clamp it. Work the tire over the rim, as shown above, using a wood or steel lever, if necessary.

Slip a short piece of 3/4"-diameter rod or pipe between the tire and wheel. Roll the pipe around the rim once to equalize the tire's elasticity. Squeeze a small amount of industrial rubber adhesive (3M-TIRE, 888-622-7837, onto a scrapwood applicator and apply it to the tire and wheel surface, as shown below left. Roll and repeat all the way around the rim. Let the adhesive dry for 24 hours before using the saw again.

Note: Bandsaw tires fit a range of wheel widths, and may require trimming along one edge. Mount the tire flush to one side of the wheel, glue it in place, and then run a sharp utility knife around the edge.


Urethane tires: Heat 'em and seat 'em

Urethane tires: Heat 'em and seat 'em

Urethane tires come slightly undersized so you can install them without adhesive for a firm hold. If you have limited hand strength, soak the tire in hot water -- up to 120° F -- for 5 minutes to make it pliable enough to stretch over the rim.



Wood Magazine