Get more from your mortiser
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY!
(U.S. orders only) (Click here for Canadian orders)

Email:

First Name:

Last Name:

Address:

City:

State:

Zip:

100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.
Wood Magazine

Get more from your mortiser

These tips will increase accuracy and decrease working time

If you plan to do a lot of mortising, a benchtop mortiser, saves time by boring square holes. But they're not always the easiest machines to operate -- especially for first-time users -- so apply these helpful hints for best results.


 

Bit and chisel offset

Bit and chisel offset

The mortiser's square hollow chisel and the drill bit inside it work in tandem: The bit removes most of the waste while the chisel pares away the edges and corners. Proper spacing between the chisel tips and bit ensures the bit clears a path for the chisel. Here's how to install them: Slide the chisel (with the bit inside) into the mortiser collar, inserting a dime as shown right to keep it from fully seating, and snug the setscrew. Next, raise the drill bit into the chuck until it seats against the chisel, and tighten the chuck. Finally, loosen the setscrew, remove the dime, and seat the chisel tightly against the collar while simultaneously squaring it to the mortiser fence, as shown below right. Tighten the setscrew, and you're ready to cut.


 

Add a quick hold-in

Add a quick hold-in

High-end mortisers use built-in rollers to hold a workpiece tight against the fence. You can add that workholding ability using a couple of Magswitch MagJigs [Sources, slide 5]. Simply secure two MagJigs on the cast-iron base as shown right. The magnets' rounded ends hold the workpiece against the fence without marring.


 

Lubricate the column

Lubricate the column

Most benchtop mortiser heads slide up and down on a dovetailed column. To minimize metal-on-metal friction, apply a lubricant that dries without leaving a residue, such as Bostik TopCote or Empire Dri-Tool [Sources, slide 5]. A lubricant that leaves a greasy or oily residue will attract dust, requiring more frequent cleaning and relubricating.


 

Cut mortises deeper than needed

Cut mortises deeper than needed

Because of the cutting geometry of the drill bit and chisel, they won't leave a perfectly flat-bottomed mortise (right). To avoid time-consuming clean-up of the bottom with a chisel, set the depth stop to bore 18" deeper than the length of the tenon. This way, the extra wood will not interfere with full insertion of the tenon.

Sources
Bostik TopCote: 10 oz aerosol can, amazon.com.
Empire Dri-Tool: 2 oz pump-spray bottle, #EMMOCDTS2B, International Tool, 800-338-3384, internationaltool.com.
Magswitch MagJigs: 20mm (diameter) jig, #21910; 30 mm jig, #28844, Rockler Woodworking & Hardware, 800-279-4441, rockler.com


 

shim

Wood Magazine