Trim edge banding, the sequel
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Wood Magazine

Trim edge banding, the sequel

A notched spacer for proven results

Simple setup for trimming the ends off banded pieces

Simple setup for trimming the ends off banded pieces

A shop-tested technique to flush-trim the excess length from solid-wood edge banding. Cut a notch just a whisker wider than your saw blade in a piece of scrapwood spacer, as shown. Again, position your fence so that the outside edge of the spacer is flush with the outside of the blade, and make a test cut. Finally, trim off the end of the banding.


If you like this project, please check out more than 1,000 shop-proven paper and downloadable woodworking project plans in the WOOD Store.


 

shim

Wood Magazine