Hang-and-go lathe-tool holder
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY!
(U.S. orders only) (Click here for Canadian orders)

Email:

First Name:

Last Name:

Address:

City:

State:

Zip:

100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.
Wood Magazine

Hang-and-go lathe-tool holder

When you create a mountable chisel caddy, who says it has to stay in one place?

This quick-to-make project slides between the rails in the lathe bed (known as the ways) and cradles turning tools within arm's reach. When not in use, it hangs on the wall, out of the way. Feel free to customize it for the type and number of turning tools you own.

To size your tool holder, first measure the overall length of your turning tools to determine the length for the backboard (A). The one here is 21", just a bit shorter than most of the tools. Now, measure from the butt end of the handles to the ferrules (the rings on the handles near the blades). This determines the distance between the upper rest (B) and base (D), as shown.

Next, measure the diameter of each tool's ferrule and of each handle 2" from the butt end. Cut two 2x10 3/4" plywood strips to make the upper rest (B) and lower rest (C), and mark lines 1 1/4" from one edge. Lay out hole centerpoints along those lines, where dimensioned on part B, below. Drill holes to match the ferrules in one strip and to match the handles in the other. Rip the rests (B, C) to width and attach them to the backboard. Then, add the base (D). A screw in each edge of the backboard retains a 10" miniature bungee cord that secures the tools.

The cleat and retainer (E, F) are sized to fit most lathes, but check the distance between the ways on your lathe. The cleat needs about 1/4" clearance to slide easily. Make the wall-mount parts (H, I) and secure this assembly to a wall stud.


 

shim

Wood Magazine