Tablesaw Pattern Jig
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Wood Magazine

Tablesaw Pattern Jig

Cut down your time making tapered cuts using this tablesawing shortcut

Q: I'm making Adirondack chairs that have tapered rip cuts on a number of pieces. Can I make these cuts at the tablesaw?

--Brad Johnson, St. Paul, Minn.

A: You sure can, Brad, by using a technique that definitely will save you time. Begin by making a plywood pattern of each piece that requires tapered cuts. Then fasten the pattern to the stock with double-faced tape or screws. With a little planning, you may be able to position the pattern screws where you'll later make screw holes in the finished piece. Now, make a pattern-cutting jig by screwing together two pieces of plywood as shown on the drawing. Clamp the jig to your tablesaw's rip fence, and position its edge a scant 1/32" beyond the edge of the blade. Slide each pattern/stock assembly along the fence to duplicate the parts.


 

shim

Wood Magazine