Raised-Panel Pushing Jig
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Wood Magazine

Raised-Panel Pushing Jig

I really liked your technique for making simple raised-panel doors for the pine hutch in issue #147 (page 67). I've been using a similar technique for some time, and my panel-pushing jig, shown below, makes it safe and easy to cut the beveled edge on the panels.

The jig raises the pressure point on the panel, holding it tightly against the fence, and protects my fingers from the blade. I used biscuits to join the runners to the jig, but you also could dado the jig and glue the runners into place. (Note that the runners should be taller than the blade height.)

— Dan Batliner, Lincoln, Calif.


 

shim

Wood Magazine