Use a dial caliper to align your tablesaw
SPECIAL OFFER: - Limited Time Only!
(The ad below will not display on your printed page)

Free Year + Free Gift! Order NOW and get 1 FREE YEAR of Wood® Magazine! PLUS you'll get our Great Projects for Your Shop guide instantly! That's 2 full years (14 issues) for the 1-year-rate – just $28.00. This is a limited-time offer, so HURRY!
(U.S. orders only) (Click here for Canadian orders)


First Name:

Last Name:





100% Money-Back Guarantee: You must be pleased, or you may cancel any time during the life of your subscription and receive a refund on any unserved issues – no questions asked. Wood® Magazine is currently published 7 times annually – subject to change without notice. Double issues may be published, which count as 2 issues. Applicable sales tax will be added. E-mail address required to access your account and member benefits online. We will not share your e-mail address with anyone. Click here to view our privacy policy.
Wood Magazine

Use a dial caliper to align your tablesaw

When I move to a different Air Force base, one of the first things I do is check the alignment of the tools in the base’s wood shop. Lacking an expensive dial indicator or alignment tool, I built a simple jig that uses my dial caliper to do the duty.

First, I cut an 18" hardwood guide strip to fit the saw’s miter slot so the bar stands about 1/8" proud of the saw table, as shown at left. In the hardwood clamp block, I cut a dado within a dado: The first fits the dial caliper snugly to the bar, while the second provides clearance for the depth bar to move unrestricted.

Whenever I want to tune up the saw, I slide the dial caliper under the clamp block and tighten the screws. Then, using the depth bar, I check the measurement at the front and back of the blade and adjust the saw until the measurements are equal. I find I can easily tweak the saw to within .001"—far better than my old combination square.

—Frank Snock, Soham, England



Wood Magazine