You are here

Easy-Lock Feather Board

easy lock
Guarantee perfect rip cuts with this quick-to-set tablesaw helper.

Creating the feather board

When ripping stock on your tablesaw, keep it firmly and safely against the fence with this handy adjustable locking feather board. Not only does it prevent wavy cuts, it guards against dangerous kickback. To build one, use the drawing at right
and patterns on the next web page to cut handle (A) and feather board (B) to size and shape, noting the location of the angled notch and counterbored hole in the handle. Use a bandsaw to cut the 2 1/2"-long kerfs in the feather board and the curved portion of the handle, where located on the pattern. Cut the 30° angled notch in the handle's bottom edge using a dado blade in your tablesaw along with an auxiliary wood fence on your miter gauge
for support.

To finalize the feather board, countersink
and slide a 5/16" washer onto the head of
the machine screw, slide the threaded end
through the handle, and fit a washer and
4-arm knob onto the end. Fit part B into the
angled notch, and slide the bottom edge of
the handle and the washer into the mitergauge
slot on your tablesaw where shown
bottom right. If the washer is too
wide for your miter-gauge slot, you may
need to grind down the outside edges for a
good fit.

Using the feather board

With the saw off, slide the workpiece between the feather board and fence. Position the trailing edge of the feather board about 1" in front of the leading edge of the saw blade, where shown in the photos on the previous page. Put too close to the blade, the feather board can pinch the kerf and cause the workpiece to bind on the blade.

Position the shorter leading finger against the piece to be ripped. The piece should slide smoothly, yet be held firmly against the rip fence. If pushing the workpiece between the feather board and rip fence offers too much resistance, back part B off slightly. Once properly positioned, tighten the 4-arm knob to secure the assembly in place.

Project design: Vernon Lee; Scott Spierling

easy lock 2

easy lock
Read more about

Tip of the Day

Make Your Own Blade Guides of Wood

Blade Guides

While working on a project that required precision sawing, I discovered that the... read more