Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Tips for Working With Wood Figure

Pages in this Story:
Figure on some workshop challenges with this stock

Figure on some workshop challenges with this stock

The very thing that gives figured wood its beauty-grain that twists and turns its way through a board-makes it demanding to work with.

One of woodworking's basic rules-go with the grain-still applies when jointing or planing figured stock. But it becomes more difficult to follow with figured stock.

In the curly maple board left, for instance, the grain in the vicinity of the pen point appears to run to the left. Under the ferrule on the pen, however, a fold in the grain lines seems to indicate the opposite grain direction-at least for a short distance.

When surface-planing or jointing figured stock, make your best determination of grain direction. Then, adjust your machine to take a light cut-maybe 1/32" or even 1/64". (Needless to say, the knives must be sharp.) Feed the stock steadily at a moderate speed, then check the results.


gofigure3

If you see a lot of chip-out and torn grain, as in the pieces of stock right, try running the material through the machine in the other direction. A lighter cut might help, too. For final machining, choose the feed direction and depth of cut that gives the cleanest results, and mark your stock so you'll always feed it through the same way.

Sanding figured stock to thickness rather than running it through a surface planer often proves most effective. Drum surface sanders handle irregular grain with greater aplomb than thickness planers.

The ornery grain of figured wood can make sawing troublesome, too. You'll make your best cuts on figured stock by installing a zero-clearance insert in your tablesaw's throat. And when crosscutting, back the stock with scrapwood to prevent chip-out on the exit side of the cut. You'll want a sharp blade here, too.


go figure

A good approach to machining parts from highly figured stock is to cut all parts slightly oversize, then sand or plane them to finished size. A low-angle block plane like the one shown left does a great job of planing figured wood.


Continued on page 3:  Keep the figure in sight when finishing your wood

 

close


Comments (0)
8322576112

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 

 
 
Connect With Us
  • Recent Posts
  • Top Posts
See More >