Follow us on Pinterest
Welcome, Guest! Log In  |  Join Now
More
Close

Workbench serves as tablesaw outfeed, too

2 of 11
Square side on bench

Fit the end-member parts

To create the end frames I used dried 2x6 stock with both edges trimmed to remove the round corners. I glued the upright and crossmember pieces together, and later clamped the laminated uprights to the laminated crossmembers to check the fit. Then, I marked the mortise locations on the four 3"-thick uprights.

2 of 11


Comments (0)
8600657276

Add your comment

You must be logged in to leave a comment. Register | Log In

Please confirm your comment by answering the question below and clicking "Submit Comment."

 
 
Connect With Us
  • Recent Posts
  • Top Posts
See More >