Home > Community > Blogs > After Hours with the WOOD Gang
Better Blog

crosscut

Tablesaw Crosscut Sled

After spending the last two months building nearly 40 holiday gifts for family and friends, I’m really looking forward to spending the winter building a furniture piece or two. To build these presents, I needed a very accurate jig for crosscutting stock on my tablesaw, with a minimum of tear-out. To do that, I built the crosscut sled shown below.  The sled measures 24x24”. The front and rear fence are 1” thick (two pieces of ½” plywood laminated face to face) and 3” high. The fences are glued to the top of the ½”-thick plywood base. The back fence (closest to the operator) has a ¾” wide groove ¼” deep running its length.

Tablesaw Crosscut Sled

Tablesaw Crosscut Sled

 The 6” long stop has a mating cleat on its back side that slides smoothly in the groove. Read more

 
 
 
© Copyright 2014, Meredith Corporation. All Rights Reserved | Privacy Policy | By using this site, you agree to our Terms of Service.