Home > Community > Blogs > After Hours with the WOOD Gang
Better Blog

Back to the shop (cabinet)

My wife is able to drive again, so I’m slowly relegating my role of Mr. Mom. That means some shop time! Over the last month, I’ve been in and out of the shop numerous times to grab a tool, a roll of tape, or something. The only problem is my bad habit of simply setting things on the nearest horizontal surface when  done with it instead of putting it away. So I took a half-hour to refile a month’s accumulation, THEN got started on my cabinet again.

The backs have been installed, and door latches, too. Because my dovetail jig is part of the clutter that is still waiting for a home in the new cabinet, I decided I might as well put it to use and dovetail the drawers. It’s been a while since I’d used it, so I went through the drill of mounting the guide bushing in the router, adjusting the template and stops, and cutting some test joints. All that time made me wonder if it was worth it, but having seen our dovetail showdown, I figured the setup time would pay off.

Next, I refigured the height of the drawers to put a half-pin at the top and bottom. Then I started rough-cutting lumber for the drawers. I came across a stash of enough scrap to make a couple of drawers…so there will be a mix of poplar and oak drawer cases. (And probably one that mixes poplar and oak. Hey, it’s just a shop cabinet.)

After gluing up four panels for the widest drawers (10 15/16″), I’d come to a point where I had nothing much to do, and still plenty of time to do it in. (I wish I could get to that point more often.) So I decided I might as well paint the carcases.

Still to come is milling the rest of the drawer case parts, and then making a pile of sawdust by dovetailing them.

Craig




 
 
 
© Copyright , Meredith Corporation. All Rights Reserved | Privacy Policy | By using this site, you agree to our Terms of Service.